So I'm trying to set the bias according to the manual and I seem to be unable to see any current. Every time I adjust the pot the current spikes up then drops back down to 0 or .001mA. I assume I'm supposed to be monitoring DC current...
Here's the procedure:
Here's how I have it setup:
I removed the -85 lines and zip-tied the eyes together, then connected an alligator clip around them for the meter. I made a simple wire and attached the other alligator lead to the - terminal on the capacitor.
Same results for the other amp board.
I must be performing this procedure incorrectly. If anyone can let me know what I'm doing wrong, I'd appreciate it
Thanks!
Kris
Here's the procedure:
Here's how I have it setup:
I removed the -85 lines and zip-tied the eyes together, then connected an alligator clip around them for the meter. I made a simple wire and attached the other alligator lead to the - terminal on the capacitor.
Same results for the other amp board.
I must be performing this procedure incorrectly. If anyone can let me know what I'm doing wrong, I'd appreciate it
Thanks!
Kris