Hey all, I have been browsing for months now, seen a few members builds, and @speakerscotts build thread. Danley horns have always fascinated me, and I'd love a clone. I have extensive woodworking knowledge, but I am having some issues with Scott's thread and details, and ensuring I get the angles on the horn perfect, and getting the hole separation perfect.
Scott's plans mention multiple times 60x60 coverage areas. Does this correspond with the throat angles of the horn? If I go by Scott's plans to a T in SketchUp, I am getting throat angles of very near 60° laterally, but only 53° vertically. His plans work perfectly to address the small drivers exiting at 100° through the flares, but the throat angles confuse me more and more.
In addition to the above question, are there other full detail plans for a synergy horn clone or something similar with a nice large waveguide that might be easier for me for my first time?
Scott's plans mention multiple times 60x60 coverage areas. Does this correspond with the throat angles of the horn? If I go by Scott's plans to a T in SketchUp, I am getting throat angles of very near 60° laterally, but only 53° vertically. His plans work perfectly to address the small drivers exiting at 100° through the flares, but the throat angles confuse me more and more.
In addition to the above question, are there other full detail plans for a synergy horn clone or something similar with a nice large waveguide that might be easier for me for my first time?
