Okay, was contemplating a smaller driver bib and stereo subwoofer setup.
what amp was driving them?
did you do any mods to the basic drivers or design?
what amp was driving them?
did you do any mods to the basic drivers or design?
I don't remember what I had driving them, I had the option of a QSC 1.0HV, CX902, ART SLA-1, or a Pioneer receiver. I think I normally had them on the receiver, or the ART amp and occasionally the QSC 1.0HV, but they really don't need much power to get rather ridiculous. I don't believe I had any mods to the basic design, a LTA-12" driver, Fostex FT-17? tweeter, Fostex adjustable L-pad, some stuffing, ton of plywood, and a pickup with a dolly.
There should be a thread floating around where I took some pictures of these things when I built them. A 8" pair would most likely suffice just fine, and even better with a stereo stub setup.
There should be a thread floating around where I took some pictures of these things when I built them. A 8" pair would most likely suffice just fine, and even better with a stereo stub setup.
Ok, ill look at these, thinking of simplicity above all and the idea of subs and mains is a little complex for me and would end up using equivelent space it seems.
i watch a lot of movies and the current lack of bottom octave really bothers me.
The dynamics you speak of are also important as i dont want to use a high power amp, tubes if i can.
I rememeber that pic and looking at it over and over!
Ill get the lumber and post pics and stuff. Prob osb then or some inexpensive 3/4 ply.
i watch a lot of movies and the current lack of bottom octave really bothers me.
The dynamics you speak of are also important as i dont want to use a high power amp, tubes if i can.
I rememeber that pic and looking at it over and over!
Ill get the lumber and post pics and stuff. Prob osb then or some inexpensive 3/4 ply.
An externally hosted image should be here but it was not working when we last tested it.
I built these BIBs with B&C 10PS26 drivers and i have the best bass ever in my home. They go down to about 25 Hz with lots and lots of power. With 30 watts a piece they rattle everything in my house. Even the tiles outside on my roof.
I tested them as subwoofers crossed over 36 dB/octave at 80 Hz and they were very clean. No hissing or rattling. Just very deep and powerfull bass in abundance. I literally feel sick and get very dizzy if i push them to hard.
Johannes.
- Status
- Not open for further replies.