Can somebody who's pulled a old Blade series 2 amp apart give me a clue. The fets are pressed into a channel in the sink with tape and clips. Im afraid to wreck the board pulling it off. Needs a new gain pot.
blade
Probably. It's an odd way to mount them, lots of stress on the board pulling them apart. It's a 4ch amp but made with 2 2ch amps side by side in the same sink. Each channel has its own gain pot and one won't adjust low enough.
Probably. It's an odd way to mount them, lots of stress on the board pulling them apart. It's a 4ch amp but made with 2 2ch amps side by side in the same sink. Each channel has its own gain pot and one won't adjust low enough.
They made some strange amps. I think they were the same company that made the grenade amp that wouldn't function without its 'pin'.
