Sorry Allen. Very strange. It worked fine the first time I tried it. Extremely flat in room response with a slight lift below 100hz from 20hz to 7khz and then fell like a rock. Anyway, it looks like the user no longer wants to share or elaborate. Too bad. I remember when I first became a member on this site. Same thing happened to me when I tried to post an image. Instead of seeking help, I had to figure things out on my own, so I can relate if that's what he's doing.
Last edited:
Hey folks!
Sorry for getting back to you late.
I listened carefully to the speakers and especially at the tweeter, and I was clealy getting sound from it - no doubt.
I tried measure some other speakers I have with the same measuring setup, and I was getting sound all the way to 20 kHz.
I am using Room EQ and a Umik-1 microphone. I am also connecting the BeoLab 5 to my MacBook Pro through Beosound Essence MKII.
Any new ideas why I get the dip at 7 kHz?
Sorry for getting back to you late.
I listened carefully to the speakers and especially at the tweeter, and I was clealy getting sound from it - no doubt.
I tried measure some other speakers I have with the same measuring setup, and I was getting sound all the way to 20 kHz.
I am using Room EQ and a Umik-1 microphone. I am also connecting the BeoLab 5 to my MacBook Pro through Beosound Essence MKII.
Any new ideas why I get the dip at 7 kHz?
Last edited:
Maybe this will help(I haven't read it). Or maybe turning it off(Unplugging) and back on to reboot the software?
https://bangolufsenassistentgohe.blob.core.windows.net/manuals/SPEAKERS/BEOLAB_5/EN-BeoLab5.pdf
https://bangolufsenassistentgohe.blob.core.windows.net/manuals/SPEAKERS/BEOLAB_5/EN-BeoLab5.pdf
I have tried rebooting everything multiple times �� Do you think it will help to connect to the B&O with cable instead of Bluetooth?
So it says unplug from the mains for 3 to 5 minutes to reset, but it may not help for this particular situation
Also, is the umic-1 high enough to actually "see" the tweeter?
Also, is the umic-1 high enough to actually "see" the tweeter?
Last edited:
I have tested the Umik with other speakers and it measures valuta from 20 Hz to 20 kHz there without any problems. I just dont understand this.