Just built some open baffles same as this design.
Endorphine from Kingston Kitchen
My front baffle thickness is 2.5 cm thick MDF. I am using a BMS 18" driver.
For this to sit flush It would need a 1.5cm recess.
Which would leave 1cm left on the baffle to screw the driver into - Is this enough?
Endorphine from Kingston Kitchen
My front baffle thickness is 2.5 cm thick MDF. I am using a BMS 18" driver.
For this to sit flush It would need a 1.5cm recess.
Which would leave 1cm left on the baffle to screw the driver into - Is this enough?