I have one B&G RD-40 where one of the ribbon "tracks" is broken. There is just a very tiny crack, impossible to see with the bare eye.
Any ideas on how to try a repair?
Any ideas on how to try a repair?
I was hoping to do a repair without taking the driver apart. Using the copper tape (or alu tape) would work, but applying the "patch" (so to speak) will require just that.
I was thinking of applying a small drop of conductive glue - if such a thing really exists?
I was thinking of applying a small drop of conductive glue - if such a thing really exists?
Silver Conductive Paint | Z05001 | SPI Supplies
unfortunately something like this may be your only option
I haven't used so cannot say for sure BUT I suspect if you put enough layers on it may be low enough resistance to work but may not hold up long. Just not sure
unfortunately something like this may be your only option
I haven't used so cannot say for sure BUT I suspect if you put enough layers on it may be low enough resistance to work but may not hold up long. Just not sure
- Status
- Not open for further replies.