Hey guys, I'm working with this audiopipe Apcl-30001d amp. This amp is a dual board bridge to a single channel. This amp has a noise in one of
the boards audio outputs. the audio drivers boards were interchanged, and there's still noise on the same board. Does anybody have a schematic that's good for this amp?
the boards audio outputs. the audio drivers boards were interchanged, and there's still noise on the same board. Does anybody have a schematic that's good for this amp?
I don't have a diagram. Hopefully someone else will.
Does the amp work perfectly up to full power on the noisy half of the amp, except for the noise?
How bad is the noise (amplitude)?
Does the amp work perfectly up to full power on the noisy half of the amp, except for the noise?
How bad is the noise (amplitude)?
No, the audio on that channel is about half of the other one.
The noise is not too loud, Somethin like scratchi.
The noise is not too loud, Somethin like scratchi.
Last edited:
- Status
- Not open for further replies.