• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Audio Note L1 type full amp

To sell a complete built kit of the Audio Note L1 Amplifier clone board, which includes:
- Full Main board totally built (it has worked for some 50 hours)
- The board has all the goodies: Audio Note supply capacitors; Elna Silmic II cathode caps for the driver tubes; Black GAte capacitors + Mills resistors for the power tubes cathodes; Schotky diodes for rectifiers; Audyn True copper signal caps.
- Inlcuded a pair of Lundahl LL1682 Output transfores, already configured for the amp.
- Included the custome Power Transformer (230Vac primary).
- Included slow start board, filaments are connected upn power on, then after 45 seconds, the B+ plate voltage.
- Included a matched quad EL84 Mullard tubes (modern fabrication).
- Included a matched pair of ECF80 Telefunken tubes.

Just had a chassis, some binding posts, a volume pot, and some line-in selector, and you'll gave a fully working super clean and top sounding amplifier.

Selling because I've changed loudspeakers and I need more power.

Total asking price is 750€ + 3% Paypal fee + shipping to be calculated depending the destination.

Drop me a PM if interesteed, I will pack everything very well and double box.

Thanks for your interest.
Regards
Rui L
Portugal
 

Attachments

  • AMP1.jpg
    AMP1.jpg
    112.7 KB · Views: 302
  • AMP2.jpg
    AMP2.jpg
    122 KB · Views: 295
  • AMP3.jpg
    AMP3.jpg
    438.4 KB · Views: 298
  • AMP4.png
    AMP4.png
    728.4 KB · Views: 291
  • Like
Reactions: pompiliu