Hey guys, just wanted to see if anyone is available to help. My ecobee3 stopped being able to turn on anything it controls so I traced the issue to the PEK pin - wanted to see if anyone can take theirs apart right quick to see if:
pek pin has continuity to test point 88 or TP88 - and where else on the board it has continuity to?
*EDIT* In case anyone else has this issue, I fixed mine...I ran magnet wire from TP119 to the PEK Pin.
P.S. ~ These ecobees are probably the best thermostat out there but they are not durable. The nest is 1000 times more durable than ecobee.
pek pin has continuity to test point 88 or TP88 - and where else on the board it has continuity to?
*EDIT* In case anyone else has this issue, I fixed mine...I ran magnet wire from TP119 to the PEK Pin.
P.S. ~ These ecobees are probably the best thermostat out there but they are not durable. The nest is 1000 times more durable than ecobee.
Last edited: