For the phono preamp in a Sansui AU9500, tried bc550 as a cross reference but as I suspected they just aint close enough.
Any ideas where I can get som 2sc1313s? or a better match for a replacement?
I'm in New Zealand, which can make getting parts kinda tricky - ie. $NZ30 shipping for a $NZ0.60 part, but no one seems to have any stock at all.
Cheers,
Steve.
Any ideas where I can get som 2sc1313s? or a better match for a replacement?
I'm in New Zealand, which can make getting parts kinda tricky - ie. $NZ30 shipping for a $NZ0.60 part, but no one seems to have any stock at all.
Cheers,
Steve.
Beta (min) is rated at 600 @ 1 mA on the 2sc1313. Possible substitutes are:
bc550c (handpick for beta > 600)
2sc1845/ksc1845
2sc3112 (beta >1500)
mpsa18
2n5088 (Vceo = 30v only)
The least expensive and easily available choices are the first two - just buy a few dozen each and hand-pick for beta.
bc550c (handpick for beta > 600)
2sc1845/ksc1845
2sc3112 (beta >1500)
mpsa18
2n5088 (Vceo = 30v only)
The least expensive and easily available choices are the first two - just buy a few dozen each and hand-pick for beta.
Saw this thread and I was wondering if anyone has used KSA1845PTA as a 2SC1313 replacement? I am trying to find replacement transistors for a Pioneer SX1010 phono preamp section board.
...I was wondering if anyone has used KSA1845PTA as a 2SC1313 replacement?
YMMV - the ksc1845 'F' and 'E' grade devices are more likely to yield a close Hfe match to the 2sc1313. However, if the application doesn't require a high-beta substitute, the lower beta 'P' grade ksc1845 should work fine.
- Status
- Not open for further replies.