Hi All,
For my Masters degree, I am building a depth recorder with time stamp .
I have already written the sketch for converting the output from the depth sensor to metres.
However, I need help in writing the rest of the sketch for the RTC and SD recorder.
I am using a UNO clone with an Adafruit clone SD/RTC board.
Can someone help with writing the rest of the sketch ?
EDIT: PMs welcome
Thanks
Andy
For my Masters degree, I am building a depth recorder with time stamp .
I have already written the sketch for converting the output from the depth sensor to metres.
However, I need help in writing the rest of the sketch for the RTC and SD recorder.
I am using a UNO clone with an Adafruit clone SD/RTC board.
Can someone help with writing the rest of the sketch ?
EDIT: PMs welcome
Thanks
Andy
Attachments
Last edited:
Probably best to look for some help on one of the Ardiuno forums on the Internet.
BTW, mbed.org is another very good platform. ARM based with lots of peripherals and software routines for dozens of different sensors. Programming is via the mbed web based compiler C++
BTW, mbed.org is another very good platform. ARM based with lots of peripherals and software routines for dozens of different sensors. Programming is via the mbed web based compiler C++
- Status
- Not open for further replies.