Thanks Eldam, we really need a build thread dont we. I know all the info exists, but if you haven't followed all these long threads then there is a lot of information to digest, and a lot contradicts.
🙂 : http://www.diyaudio.com/forums/digi...nction-tda-1541-build-thread.html#post4009125
Read the first post : there are link about tubes section, an other about input stage... for an easier reading and interactions.
All the others questions can be asked in the the building thread...
Read the first post : there are link about tubes section, an other about input stage... for an easier reading and interactions.
All the others questions can be asked in the the building thread...
Are you sure they are genuine... where did you buy it : eBay or Mouser/Digikey🙂 I'm suscpiscious with the active components.... Yesterday I was walking in the street then I saw a Wookie... a chinese fake it was just 2 m tall and has a t-shirt with " I love Hymalaya !"
Ryan, with the simple shematic of Sen, could we have the same resut with a veroboard by ourselves ?
Hi Damien,
Yes, you will get a good result but when i put the circuit onto a proper board it sounded better.
No not yet but getting there put smd caps on last night, I am using a heavily modded ebay kit i had lying round with red baron shunts. amazed at what i am hearing just great again.
:
🙂🙂🙂🙂🙂🙂🙂🙂🙂🙂🙂🙂🙂🙂
I surmise it will be better with the Distinction-1541 and good inter connecting...
Let us know what values you choose for decoupling & DEM cap ? Did you use 6k8 resistor around the DEM cap ?
Last edited:
As promised, the list of interest is started.
http://www.diyaudio.com/forums/digi...-jitter-crystal-oscillator-4.html#post4057057
- Status
- Not open for further replies.