Hi,
sometime it is adviceable to prefer a LC power supply filter over a CLC one, i.e. an inductor as the first filter element. Given a two way rectifier with a vacuum or a gas filled double diode with direct heating. Usually the first filter element is connected to the center tapped heater winding. Is it a good idea to connect a center tapped choke in parallel with the heater winding and connecting the first filter cap to it's tapping, so that this choke works as the L input? By this way, I think, a gapped core is no more necessary, so the needed inductivity could be achieved by less turns.
Or is it better to use a bifilarly wound choke with a gapped core for this duty?
Best regards!
sometime it is adviceable to prefer a LC power supply filter over a CLC one, i.e. an inductor as the first filter element. Given a two way rectifier with a vacuum or a gas filled double diode with direct heating. Usually the first filter element is connected to the center tapped heater winding. Is it a good idea to connect a center tapped choke in parallel with the heater winding and connecting the first filter cap to it's tapping, so that this choke works as the L input? By this way, I think, a gapped core is no more necessary, so the needed inductivity could be achieved by less turns.
Or is it better to use a bifilarly wound choke with a gapped core for this duty?
Best regards!
AC goes in two directions, how do you see "opposite" ?So, which inductor will be use for this design?considering the AC-DC opposite directions?
Mona
Choque input filter is my prefered, but in your case you will need a large choque capable of carrying heater current (Several amperes) with negligible DC loss, but with sufficiently high inductance to provide choque input action. So it will be very large, bulky and expensive, although it can run.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.