An F1 clone comes alive (better late than never:)

[cfcubed]

Re: Re: PCB's

here are some pcb's

also here

First one (suds) are good but could take a long time to get to US & shipping is expensive... Best if a couple/few US folks got in on a suds order I'd think.

Second one (hifimaker) does not look those boards will see the light of day.

I may go ahead & sell my single set of 2 F1 channel boards (no PS board) look here, since I'm not sure I'll ever build them out...

 

[cfcubed]

F2 only, F1 in an 8 inch cube

In case anyone is following along...

While having F1 / F2 switchable was fun and it let me pick a fav w/my HSHs (the F1), novelty has worn off & these should be 2 amps.

So, the big, honking case is now a simple F2:


And the F1 banks are going into 200mm (less fins) cube. It'll be remote "on/off" using 120v relay through zipcord plug to my preamp's switched outlet (10A relay contacts, 120v A/C coil):


Interest part of build will be taking a hacksaw to those long, perfectly working F1 boards🙂

 

[ffarges]

It's a very old post and indeed a some good thinking. I'm thinking the same line to put 2 NP amplifier on the same enclosure - not running at same time - and switch to choose which one to power up.

Is there any one here that has done it ? Any restriction?