Hello all,
My first post with a question🙂
I am looking for a amplifier with high input to power my DIY sub .
If possible no plate amp ,something like a Reckhorn sub amp.
This has (crossover) adjustment in it ( not wat I want).
There is no low output available (and is in my opinion not the way to go)
I am doing a diy crossover with high end components
Summery :I need a straight amp (500 watt at 2 ohm RMS) with high input and no correction .
Not a very common setup I know.
My search on the net for a amp like this has not produced a lot options.
Has anyone ever heard or seen an amp like this ?
Al input is Welkom.
Best regards Ron
My first post with a question🙂
I am looking for a amplifier with high input to power my DIY sub .
If possible no plate amp ,something like a Reckhorn sub amp.
This has (crossover) adjustment in it ( not wat I want).
There is no low output available (and is in my opinion not the way to go)
I am doing a diy crossover with high end components
Summery :I need a straight amp (500 watt at 2 ohm RMS) with high input and no correction .
Not a very common setup I know.
My search on the net for a amp like this has not produced a lot options.
Has anyone ever heard or seen an amp like this ?
Al input is Welkom.
Best regards Ron
Look for an IRS2092 based amp. I had the Sure 250w stereo one that can be bridged. I had an exterior active electronic xover. It's working fine, my friend still has his.
On the other hand, if you want to play it at a very high volume and for a long time, it would be better to add a fan.
On the other hand, if you want to play it at a very high volume and for a long time, it would be better to add a fan.
Last edited:
Look at classdaudio.com.
Warning years ago I had one of their low end amps and didn't particularly like it. But my situation was completely different than yours.
Warning years ago I had one of their low end amps and didn't particularly like it. But my situation was completely different than yours.
Thanks denbred for the links.
There is defenetly a amp in the products lists that will for fill my wishes����
There is defenetly a amp in the products lists that will for fill my wishes����
D
Deleted member 148505
Our tectonic-D500 will be available next week (at limited quantities due to mosfet shortage), it can run 500W 2 ohms for home use.
Tectonic-D500 4Ω 500W Mono Class-D Subwoofer Amp Module | jlelectronicsph
Or TPA3255 based 400W 2 ohm
TICore400M TPA3255 Mono Single Supply 48V RTR Amplifier Module | jlelectronicsph
Tectonic-D500 4Ω 500W Mono Class-D Subwoofer Amp Module | jlelectronicsph
Or TPA3255 based 400W 2 ohm
TICore400M TPA3255 Mono Single Supply 48V RTR Amplifier Module | jlelectronicsph
The Sure 250w is 8ohm. Is it ok to power a 4ohm sub with it?
Minimum Load Impedance : 2 Ω
Our tectonic-D500 will be available next week (at limited quantities due to mosfet shortage), it can run 500W 2 ohms for home use.
Tectonic-D500 4Ω 500W Mono Class-D Subwoofer Amp Module | jlelectronicsph
Or TPA3255 based 400W 2 ohm
TICore400M TPA3255 Mono Single Supply 48V RTR Amplifier Module | jlelectronicsph
Nice products.
- Home
- Amplifiers
- Class D
- Amplifier search