I just finished my first of two Amp Camp 1.8 builds. The left channel sounds great. My right channel is not working. The led lights up fine but that is about it. I can't feel any heat building. Anyone have any suggestions on where to start troubleshooting (or how?) All of the soldering appears solid. Should I try taking off the heat sink to view the back? Any help is appreciated.
Haz1978,
You should post your problem in the dedicated ACA thread in the Pass Labs forum:
Amp Camp Amp - ACA
You should post your problem in the dedicated ACA thread in the Pass Labs forum:
Amp Camp Amp - ACA
Figured it out. Took the heat sink off the back and found an open solder joint. Just tried to finesse the solder job too much. Thanks for looking.