There is no contrary information there.....I am just passing along the quote from the original board house for a repeat order.
Its a sweet board and I have 3 or 4 of them in my amps & preamp s. I asked Ti about adding some kind of delay and remote trigger function to it so you could put a master in a preamp and slave in the amp. He suggested a time delay relay, that didn't sound to practical. I just built a Aussie amp NVX500 for some future electrostatic speakers and used it. Anthony liked the switch and was thinking of putting something together along the lines of what I wanted.
Bill
Bill
OK, so 4 weeks is the approximate Fab time for these so once I get them I will collect payment via Paypal (+3%) or check in the mail either way.... and send them out!
howdy on this side of the 'net 🙂 I ordered a pair of the 1.2VA versions today from Digikey and am expecting them to work fine in my application (SSR). I'll report back when I try them, assuming the speced part isn't back in stock by then.
I can also order the trafo's once they get into digi-key. its part # 567-1031-5-ND which drops the price down from 3.18 to 1.96 if I order all 25!. (this may bump shipping up but I am sure not by much.
So I am not sure I would have everyone's consesus on the trafo's and I need all 25 to get a price break... so thats probably a no go. Boards should be shipped to me hopefully the week of the 28th. Once I get them here I will collect payments and mail them out!
MrMajestic what did you need?
MrMajestic what did you need?
Eeek, potentially more... just found an awesome site which sells some more goodies and these would be awesome for it 🙂
I can do 5 more max! I think they will be around ~$6.50 ... shipping to you may add a little more.
- Status
- Not open for further replies.