Greetings . This is the 1st thread I have posted.
Pardon my poor english.
My question is regarding a pair of 802 8g that I have acquired over ebay. They came without neither diaphraghm nor the bolts for mounting the diaphraghm. I understand that diaphraghms can be bought from great plains audio. However I need directions for the bolts. Bolt size measurements should suffice as we have a shop that specializes in selling nuts and bolts over here.
Thank you in advance .
Pardon my poor english.
My question is regarding a pair of 802 8g that I have acquired over ebay. They came without neither diaphraghm nor the bolts for mounting the diaphraghm. I understand that diaphraghms can be bought from great plains audio. However I need directions for the bolts. Bolt size measurements should suffice as we have a shop that specializes in selling nuts and bolts over here.
Thank you in advance .
I bet GPA can help you with the bolt sizes, too. There's an Altec specific forum if you don't get answers here:
Altec User's Board
Altec User's Board
Just to be sure, you might want to send them to GPA as they will also remagnitize them when they put new diaphragms in. I had them do my 288's with the 8 ohm aluminum ones.
I see. Thank you both. Hahaha sending the drivers to GPA would be pretty hard for me as I just got them off ebay shipped from the US . So shipping the drivers back to the US would be a huge hit to my already shallow pockets.
- Status
- Not open for further replies.