• Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.

Alps 50K: How to wire

Status
Not open for further replies.
Jump to Latest
#4
alps Pot

Just to make things simple, position the pot so the shaft is facing you. the pins from left to right are as follows. the far left pin is your signal input,the middle is your wiper which is your output and the right pin is grounded.
 
Status
Not open for further replies.
Top Bottom