Hi all!
I have finally gathered all the parts for my Aleph60´s and are ready to start soldering........but managed to get some last minute confusion......
In the schematic found in the servicemanual I noticed that the resistors marked R21 and R19 have pretty "odd" values.....
R19=1501 (would this be 1,5k?)
R21=5622 (would this be 5,62k?)
Needless to say, I am new to this and it takes almost nothing to confuse me
Cheers
Mats
I have finally gathered all the parts for my Aleph60´s and are ready to start soldering........but managed to get some last minute confusion......
In the schematic found in the servicemanual I noticed that the resistors marked R21 and R19 have pretty "odd" values.....
R19=1501 (would this be 1,5k?)
R21=5622 (would this be 5,62k?)
Needless to say, I am new to this and it takes almost nothing to confuse me
Cheers
Mats
Thanks Freddie
Ooops!
Thanks!
(I managed to switch them around in my previous post, but you cleared it up anyway!)
Good thing that I asked, otherwise I would have soldered in 5,62k......now I´m off to the store for the last components!🙂
(I´m so excited I barely can stand myself )
Cheers
Mats
Ooops!
Thanks!
(I managed to switch them around in my previous post, but you cleared it up anyway!)
Good thing that I asked, otherwise I would have soldered in 5,62k......now I´m off to the store for the last components!🙂
(I´m so excited I barely can stand myself
)Cheers
Mats
- Status
- Not open for further replies.