Hi!
My Aleph2 - work and are very happy!🙂🙂
It exat what I wanted to search for the two Eminence Alpha15 "in Open Baffle-bass ... wonderful! Such precision and power I never once heard any!
After 3 hours heatskins (400x300x85mm)temperature is 50 degrees (Bias 3A) and
Uout - 3.1 mV and 2.9 mV.
Thanks to everyone on this forum for help, and especially Nelson Pass for this great amp!
Best regards,
Vitali
My Aleph2 - work and are very happy!🙂🙂
It exat what I wanted to search for the two Eminence Alpha15 "in Open Baffle-bass ... wonderful! Such precision and power I never once heard any!
After 3 hours heatskins (400x300x85mm)temperature is 50 degrees (Bias 3A) and
Uout - 3.1 mV and 2.9 mV.
Thanks to everyone on this forum for help, and especially Nelson Pass for this great amp!
Best regards,
Vitali
Attachments
Last edited:
Fugly !
it helps if you don't have choked Heatsinks from bottom side ;
make feets taller , or make narrower platforms
it helps if you don't have choked Heatsinks from bottom side ;
make feets taller , or make narrower platforms
Very nice! I have, however, one reservation. The amp-stands have the same width as your amps. This could seriously limit the air flow through the heatsinks ...
What mesh have you used for the ventilation holes?
I need to do something similar, and am trying to get ideas.
I need to do something similar, and am trying to get ideas.
I think a good idea to make a mesh of ventilation , but do not believe me 🙂
After five hours heatskins have 48 ... 50 degrees.
I use aluminum window screen material and epoxy. You can use a block of wood and wax paper to keep them flat and tight til the epoxy sets up.Then the wax paper peels right off.
Your appreciation means a lot to me !
Thank you very much Mr. Nelson Pass 🙂🙂
Best regards,
Vitali
- Status
- Not open for further replies.