Thank you Zen. I am all set.
Hi Mike,
Yes, using 1 Ohm source resistor. I wanted to try higher bias, so was confirming.
Thank you.
Hi Mike,
Yes, using 1 Ohm source resistor. I wanted to try higher bias, so was confirming.
Thank you.
Last edited:
Just curious what part you used for Q5 and if you measured the voltage between Q5's base and emitter?
Hi Dennis
Earlier I was using BC but before taking/posting measurements I switched to MPSA18
Base-Emitter voltage is 0.632V
Earlier I was using BC but before taking/posting measurements I switched to MPSA18
Base-Emitter voltage is 0.632V