Hello all,
I am hoping to test my new Aleph 3 boards before I assemble the final amplifier and go to the effort of matching fets. I was contemplating assembling a board with only a single pair of output fets rather than the usual 4.
As far as I can tell the circuit will work ok with a single pair of output fets without modification. Is this correct or am I going to fry something?
Your advice is appreciated.
Greg.
I am hoping to test my new Aleph 3 boards before I assemble the final amplifier and go to the effort of matching fets. I was contemplating assembling a board with only a single pair of output fets rather than the usual 4.
As far as I can tell the circuit will work ok with a single pair of output fets without modification. Is this correct or am I going to fry something?
Your advice is appreciated.
Greg.
There's the mini-Aleph (AKA mini-A)that uses one pair of (unmatched) IRF240's per channel. It's almost identical to the Aleph 3.
http://www.diyaudio.com/forums/pass-labs/2001-mini.html?perpage=25&pagenumber=1
http://www.diyaudio.com/forums/pass-labs/2001-mini.html?perpage=25&pagenumber=1
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.