• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Aleph P1.7 assembled board

Aleph p1.7 completed board for sale.
Solid brass bar keeps all mosfets equally hot, relays are itt, gain fets are harris devices, attenuator section uses sfernice resistors and some nos siemens 0.1% resistors. In/out capacitors are roederstein mkc, capacitance is smaller than advices 10uf, but if load is not tough its alright.
Ps photos are from construction, bad soldering on adc chip is corrected.
Asking 230 euro.
Board size 20x30 cm


20230820_180043.jpg
20230924_114029.jpg
 
Will throw in this very nice input selector 6 pole 3 position, and all the rca connectors, neutrik. Plus a spool of solder, 250gram 96sc.
Better?
 

Attachments

  • 20231010_091414.jpg
    20231010_091414.jpg
    423.5 KB · Views: 125
  • 20231029_115130.jpg
    20231029_115130.jpg
    362.1 KB · Views: 127
  • 20231010_092102.jpg
    20231010_092102.jpg
    376.6 KB · Views: 123
  • 20231010_091357.jpg
    20231010_091357.jpg
    504.8 KB · Views: 114
  • Like
Reactions: arteom