I bought a second hand aikido octal kit. The preamp is just finished. In the kit there was an a3 stepped attenuator. There where no instructions but all resistors where in marked bass, so I solder it togheter. When finnished I wanted to check that everything is rigt.
But I only got same Reading (around 100k) when messuring between input and output regardless off switch posisjon.
Shouldent the value change? Not much to do wrong with that pcb.
But I only got same Reading (around 100k) when messuring between input and output regardless off switch posisjon.
Shouldent the value change? Not much to do wrong with that pcb.
Look it up on the Glassware Audio website - the explanation page is pretty clear - there's a choice between 20k or 100kR.
I know. The question is : how to messure if everything is Mountain corectly. I dont want to Mount it an blast my speakers with full volume