After search...need schematic to stereo preamp with only 4 bjt transistors

Status
Not open for further replies.
I did excatctly like this .

I used only 2 transistors , BC550c NPN and BC556 PNP
 

Attachments

  • 66.png
    66.png
    52.9 KB · Views: 200
So using the values you have we get the following...

Look how the 0.47uf cap limits the low frequency response and how raising it extends the response. An electroylitic is fine here (watch polarity).

Also see how the response of the amplifier falls at high frequecies. With the higher gain the 100pf cap is limiting the bandwidth. Look at the difference between 100pf and 22pf.

Five screenshots showing this,

1) Output Max. Your amp as it stands into 100k
2) Response. Your amp.
3) Response larger value C1 shows extended LF response.
4) 50Khz squarewave. Your amp as it stands.
5) Lower value of C2. Extends the HF response.
 

Attachments

  • Output Max.PNG
    Output Max.PNG
    127.2 KB · Views: 176
  • Response.PNG
    Response.PNG
    123.5 KB · Views: 174
  • Response larger C1.PNG
    Response larger C1.PNG
    122.5 KB · Views: 160
  • 50Khz Squarewave.PNG
    50Khz Squarewave.PNG
    126.4 KB · Views: 162
  • Lower value C2.PNG
    Lower value C2.PNG
    126 KB · Views: 111
Status
Not open for further replies.