hello everyone, so I’m trying to mod my Onkyo receiver, and I would like to add some pre-outs to it
I have been looking at the service manual and if you look at the picture below, I think this is the preamp section where I should tap to get the pre-out.
This is the first time I’ve tried doing anything like this, and I would really like some tips.
thank you very much. Looking forward to start a discussion.
I have been looking at the service manual and if you look at the picture below, I think this is the preamp section where I should tap to get the pre-out.
This is the first time I’ve tried doing anything like this, and I would really like some tips.
thank you very much. Looking forward to start a discussion.
This is the service manual
I don’t know much about electronics and schematics but I think I can get the pre outs from p6002a p6001a p6000a ( L C R ) on the BACLA-1734 board
I don’t know much about electronics and schematics but I think I can get the pre outs from p6002a p6001a p6000a ( L C R ) on the BACLA-1734 board
That's a copious meal to digest... takes some time (burb).
Saw the MP Meaning of Live tonight: It's only a mint chocolate.
Saw the MP Meaning of Live tonight: It's only a mint chocolate.
Looks like if you change the Q4130 pin #5 connection from ground to instead Q4130 pin #3,
and then take the pre out signal from Q4130 pin #7, that will give you a buffered preamp output.
Use a series 10uF 35V NP coupling capacitor to each RCA pre out jack, if you like.
Note that IC packages are numbered counter-clockwise from the dot or notch, as viewed from the top.
and then take the pre out signal from Q4130 pin #7, that will give you a buffered preamp output.
Use a series 10uF 35V NP coupling capacitor to each RCA pre out jack, if you like.
Note that IC packages are numbered counter-clockwise from the dot or notch, as viewed from the top.
Last edited:
Yes, but the signal is taken from the input to the SW filter.
There's a spare op amp not being used.
There's a spare op amp not being used.