Adcom GFA-555 MK II P/S cap position

[embrown057]

I'm in a jam of sorts, I recived my new BCH 15k@100 v caps today for my 555 MKII . The problem is I always write down or draw a picture but today I did not. I have the caps installed like the older gfa555 and need to know if it;s correct before I fire it up This what I have:
Front Panel

left side front right side front
- + + -


left side rear right side rear
+ - - +

Rear heat sink

so looking at the amp from the rear this is what I have. I am just not sure it is the same as the GFA 555 ver I as this is a GFA-555 MK II

Thank's in advance

 

[embrown057]

Well. Just followed the schematic and wired it right up.
Front of amp facing you;
Left front left rear
+ - - +

right front right rear
+ - - +
This is only for the Adcom GFA-555 MKII