Hello everyone. I am new to audio and I have a module for my Eurorack synthesizer (Expert Sleepers - ES-3 Lightpipe/CV Interface) that has an ADAT input and outputs CV. All I need to know is.. I want to connect this to my PC, and what should I use for that? (I have USB, not Firewire).
I'm no expert in pro audio interfaces but If I understand you correctly, you are converting an ADAT output to analog and then want to take the analog signals into a PC.
Is there a reason why you don't use an ADAT / PCI or USB convertor?
I use an older version of this card for ADAT into my PC
Also, check out something like this
Is there a reason why you don't use an ADAT / PCI or USB convertor?
I use an older version of this card for ADAT into my PC
Also, check out something like this
You will need either an internal audio card that supports the lightpipe interface or
an external interface connected by USB.
You may have better luck finding an answer here
an external interface connected by USB.
You may have better luck finding an answer here
- Status
- Not open for further replies.