Hi all. I currently have a Pionner 7.1 1014 reciever that powers my 5.1 speaker setup. Is it possible for me to use my pioneer to feed a signal to a Berhinger CX3400 and then my custom built front speakers along with the pioneer also pumping out the normal rear, centre and sub?
Many Thanks
Mike
Many Thanks
Mike
Thank you.
Mine has the following:
5.1 channel input & 7.1ch Pre- Output
Would that be right?
Regards
Mike
Mine has the following:
5.1 channel input & 7.1ch Pre- Output
Would that be right?
Regards
Mike
- Status
- Not open for further replies.