An externally hosted image should be here but it was not working when we last tested it.
What does mean the red part?
How should i connect the input?
Thanx!
Red part
Instead " red " part you can connect any signal source - you must only imagine, that one pole of signal source is connecected to the ground 🙂 .
Instead " red " part you can connect any signal source - you must only imagine, that one pole of signal source is connecected to the ground 🙂 .
RE
As mentioned in the earleir reply this is not a part, rather this is the place where u apply output from say a preamplifier or equalizer.
Its INPUT
As mentioned in the earleir reply this is not a part, rather this is the place where u apply output from say a preamplifier or equalizer.
Its INPUT
- Status
- Not open for further replies.