Hi all, I would like to add two F12G subwoofers to P3ESR. I wondered if there is any simple software where I could simulate the frequency response.
P3ESR has a 12db/octave roll off and -3db at 75Hz. I planned on using a default crossover option on F12G (AVR/12) which works as a LPF with 12db/octave.
The idea is to simulate several scenarios and one of which will include "better" bass roll off. In other words, I will not try to get a flat bass to 20Hz, but let's say set the crossover on the subwoofer to 50Hz and see what the freq response would look like. The goal is to slightly extend and increase bass roll off.
I hope this makes sense.
P3ESR has a 12db/octave roll off and -3db at 75Hz. I planned on using a default crossover option on F12G (AVR/12) which works as a LPF with 12db/octave.
The idea is to simulate several scenarios and one of which will include "better" bass roll off. In other words, I will not try to get a flat bass to 20Hz, but let's say set the crossover on the subwoofer to 50Hz and see what the freq response would look like. The goal is to slightly extend and increase bass roll off.
I hope this makes sense.
What is wrong with Excel?
Programme it within Excel and it will do a whole host of tasks.
Even better is Open Office!
Programme it within Excel and it will do a whole host of tasks.
Even better is Open Office!
- Status
- Not open for further replies.