I have 10 pcs of 6C19P thought of using some for a SE amp,they could use a OPT off 3,5-4K ohm,right?And what about using another for the driver or is the aplification to low?Better use a E81L or E208F?
Any suggestions?🙂
Any suggestions?🙂
2.5k OPT will be better than 4k,because 6c19p is low Rp tube(300-500Ohm). For driver- perhaps ECC88 or E180F in triode connection will be good.
6c19p as driver 6c19p is bad idea, because mu=2,5, but 6c19p is good driver tube for big power tubes,which like get some current to drive.
Ok,thanks for the answers,I´m thinking maybee Paralell SE with this one,should the OPT be 1K then and it should withstand about 150-190mA,right?
- Status
- Not open for further replies.
- Home
- Amplifiers
- Tubes / Valves
- 6c19p Se?