Hi, I am building a preamp for my LM3886 GC. I am basing it off of the tube gainclone from the JLTi website. In that version the output of the valve goes directly into the chip. I am wondering if anybody can give me a rough range of voltage values to expect from the valve output, based on a normal line level signal.
Thanks,
Jason
Thanks,
Jason
The 6922 is configured as a cathode follower in Joe's amp, so will have a gain just less than 1, so output voltage will be just a bit less than driving voltage.
dave
dave
- Status
- Not open for further replies.