I just won today, a eBay auction for the 3M 5450 panel with remote and manual, but no powersupply. Does anyone know what kind of connector the powersupply uses? A standard barrell type, or a more complicated DIN connection? Also, does anyone have the specs for this panel. I could find nothing on the internet. All I found was in this forum, a user stating that Lord of the Rings looked great on it.
I hope it meets my expectations, after selling my Chisholm Rainbow 20/10 panel that did so well. I regret selling it now. Will have to save up to get the holy grail of lcd projection panels, QA-2500.
Thanks,
Mark
BravoOrig
I hope it meets my expectations, after selling my Chisholm Rainbow 20/10 panel that did so well. I regret selling it now. Will have to save up to get the holy grail of lcd projection panels, QA-2500.
Thanks,
Mark
BravoOrig
lol, i was watching that auction, and i would have bid on it too, if it had a powersupply and computer link cable. I could have saved on shipping, im west of toronto, could've picked it up, but it should be a great starter panel. Once you get it, post a diagram or picture of the power input, and perhaps someone (like me🙂 ) can help you.
yeh i was watching it too.
wasn't prepared to risk it because shipping to australia is astronomical.
good luck with it dude.
wasn't prepared to risk it because shipping to australia is astronomical.
good luck with it dude.
- Status
- Not open for further replies.