3e or Wondon DSP for Active Speaker

[chienmort]

I need to develop a two way crossover for an active speaker. The active speaker will be for Bass Guitar and/or PA Top.I should add that my colleague has been designing analogue crossovers for years and has all the equipment neede to measure the speaker's performance and fine tune it


The rough spec is:

• Active crossover between the woofer and tweeter. So one input and two outputs are all I need although I could build in a subwoofer output if there is enough processing power.
• It should have phase adjustmet to time align the drivers.
• HPF at up to 24dB/octave. Frequency would be between 30-40Hz
• Parametric and.or Graphic EQ to smooth the response.

The 3e boards seem to find favour here but the Wondom system is complete, including all hardware needed to programme and operate the DSP system.


What are the advantages of each for my application? Are there latency figuires for the Analog Devices Chips?