Ok, could someone help me model a 3 way speaker in WinISD? I'm a little confused.
Do you have to model each driver separately in the same size enclosure, or is there a way to put 3 different drivers into the same enclosure to produce a single curve?
Also, how do you model a 3 way passive filter?
Do you have to model each driver separately in the same size enclosure, or is there a way to put 3 different drivers into the same enclosure to produce a single curve?
Also, how do you model a 3 way passive filter?
One more question: is the "dia" the effective diameter of the sub or some other diameter. Because the spec built into the software is not matching the effective diameter given by the manufacturer
- Status
- Not open for further replies.