Whats wrong with a tranny input stage? If you are not familiar with amp design then I wouldnt go about designing one yourself, just copy someone elses.
I noticed mention of crossing over from one set of outputs at a point above the zero volt level. That way should tend to "wash out" the crossover effects, and the higher it is the less impact it should have on the THD figure. If you would like to eliminate it fully, each set never turns off completely. Then it is class A.
Hello!!
Did You made that amp or???
Also to mentioned...Behringer in theire EP2500 or EP1500 amplifiers uses 5200/1943 transistor pairs!
Did You made that amp or???
Also to mentioned...Behringer in theire EP2500 or EP1500 amplifiers uses 5200/1943 transistor pairs!
- Status
- Not open for further replies.