This is to check if there is sufficient demand to warrant a second groupbuy of Aikido pcb's and or psu board.
Aikido PCB is US$ 9,50 (50cents go to John Broskie)
PSU PCB is US$ 9
Please post your name with quantity.
This is not a promise to do the groupbuy but to see if it would be worthwile.
Aikido PCB is US$ 9,50 (50cents go to John Broskie)
PSU PCB is US$ 9
Please post your name with quantity.
This is not a promise to do the groupbuy but to see if it would be worthwile.
An thought of redesigning it so it can also take octals?
I recall someone posting a layout that placed a 9-pin ring inside an octal ring, with jumper pads between them for easy conversion...
Anyway, I'd take 1 board if it's 9-pin and 2 if it were also octal-able.
I recall someone posting a layout that placed a 9-pin ring inside an octal ring, with jumper pads between them for easy conversion...
Anyway, I'd take 1 board if it's 9-pin and 2 if it were also octal-able.
That would be possible if you are willing to use a wire from pcb to socket. I'll wire one up with loctals some time...
Hi Phil,
Unless you want a mono preamp...you'd have to get 2 aikido's pcb's and one psu pcb.
Regards,
Bas
Compromised URL removed by ModerationThe psu can be used to power 2 channels..but it seems a lot of folks want to use true dual mono..in that case you can leave out 1 of the last two rc networks.
Last edited by a moderator:
- Status
- Not open for further replies.