Maybe I should give you a bit of encouragement? I understand perfectly what you are writing.kck87 said:
A good dictionary is here
http://www.websters-online-dictionary.org
to dell
hi dell i'm mark i'm from balamban too can u help me find some tutorial or just help what to buy or do first because i want to assemble a power amp that could drive big baffles,but i have just a little knowledge about it thank you in advance
hi dell i'm mark i'm from balamban too can u help me find some tutorial or just help what to buy or do first because i want to assemble a power amp that could drive big baffles,but i have just a little knowledge about it thank you in advance
mark
To Mark
You should try those low power amp first before you go for the monsters. May be you can try search the Leach Amp Once you successfully powered it up, then you can try building the bigger ones. Leach amp is upgradable, with minor changes you can powered it up to +/- 100Vdc with many output transistors! that's a lot of power.
To Mark
You should try those low power amp first before you go for the monsters. May be you can try search the Leach Amp Once you successfully powered it up, then you can try building the bigger ones. Leach amp is upgradable, with minor changes you can powered it up to +/- 100Vdc with many output transistors! that's a lot of power.
ok thanks man so,thank you very much,so can you give me the list of on what to buy so that i can start, where can i find the amp diagram,schematics,or the pcb,design can i buy a redy made pcb for that amp?
and dell,i have a one last favor question from you,after i made the amp does it have a specific baffle to be made or any baffle design would do? thanks again man
hi dell heres the site that i i've search for the leach amp is this the upgradable leach amp, is it ok to start assembling this amp? the site address is below pls. have a quick check then tell me if this is ok thanks man i owe you a lot.
http://users.ece.gatech.edu/~mleach/lowtim/
http://users.ece.gatech.edu/~mleach/lowtim/
Most (for that matter all) drivers cant handle 22kw of power. Were talking a driver using 4awg wire for it's VC, just not practical. Something like this will most likely be running dozens of drivers. I'd say run it at a lower voltage (say 60-90VDC per rail @ 200amps or so) and with that many FETs you could most likely make it .1ohm stable. So I'd say run a lower voltage, and have all your drivers paralleled so 20-8ohm drivers would be like .4ohms. That should work right?
For someone that doesn't understand english, its odd that he can pick off each attempt to ask him for details.
no probs moderators and administrators on the forum are very nice and willing guys .. so put everything you want to say in your language and we will translate it for you .... as long as this is done quickly i see no reason that any of these nice guys will not allow it ...
please ...times are strange and difficult can we please have some fun ????
please ...times are strange and difficult can we please have some fun ????
- Status
- Not open for further replies.