I have 2 Wharfedale Titan 15 passive speakers, Wharfedale Amp CPD 1600 and Wharfedale Connect 502USB mixer. So I connected everything but when I play music sound is coming only thru high freq part of speakers and sound is terrible, woofer part is not emitting any sound on either speakers. I don't know if I explained good because I don't have much experience, so I am posting pictures of my setup and if someone can help tell me if i connected something wrong or it is something wrong with the speakers?
2 Passive speakers setup - Album on Imgur
2 Passive speakers setup - Album on Imgur
sounds like the speakers have cross over troubles or possibly someone has changed the wiring at the speakon to bi-amp them.
can you help me how to determine what is the problem? it is suspicious that both speakers have the same problem...
i'll try.
can you tell me what the pin out of your 1/4 inch to xlr adapter is?
and do you own a multimeter (in case we have to diagnose the x-over in the speakers)?
what is the current setting of the mode switch on the amplifier?
can you tell me what the pin out of your 1/4 inch to xlr adapter is?
and do you own a multimeter (in case we have to diagnose the x-over in the speakers)?
what is the current setting of the mode switch on the amplifier?
Last edited:
ok i will send you a picture of my 1/4 inch to xlr cable if that is what you mean..
and i tried stereo mode and passive mode an the amp and i get the same result, didnt try bridge mode.
i can get a multimeter.
and i tried stereo mode and passive mode an the amp and i get the same result, didnt try bridge mode.
i can get a multimeter.
You cannot connect a stereo input to a mono input channel, the differential amp inside the mixer cancels everything that is common on the two channels which is usually all low/mid frequencies. Instead connect to the USB input if using a computer for the source or connect to one of the stereo input channels(2/3 or 3/4) with a 1/8 TRS to dual 1/4 TS cable.
- Status
- Not open for further replies.