15 watt amp need to add a line out

[ferenczy]

I have a Danelectro Nifty Seventy bass amp (15 watt) that I need to add a line out to run a mono cable into the mixer. I have a 1/4 mono phone jack and I know one side is ground, but I'm not sure where to wire the signal line to. Should it be pre-amp? Any help would be appreciated.

I've looked for a schematic, and I'm not finding one, but I assume there is a specific place where this line is usually wired. (???)

Thanks for any ideas -

ferenczy

 

[engels]

dano

I'm sure I'm a little bit late with the reply.
Anyway, the Nifty Seventy bass amp has a headphone jack which could be used as a line out. Why not take a guitar cord and plug it there?

 

[Leolabs]

You can add 2 resistors voltage attenuator.