Hi everyone,
I am looking to build tops to go over some Cubo15/Tham15s and I need them to play pretty low... 80-100hz. I initially thought single 12" were the way to go, but a dual 12" will give me some more height.
I have been looking at Rog's x12 plans , which recommends a P.Audio SN-12MB. Being in Canada that is totally out of the question to get. I do have readily available access to B&C and Eminence though, and I was thinking the B&C 12NDL76 would be a pretty good driver.
So I am assuming after handles, etc the interior volume is going to be around 75l, so I put it into WinISD, but I really don't know what I am doing. I'm not sure what my tuning frequency should be. Assuming it is 50hz which is what the 12NDL76 calls for on specs, the graph seems to fall off pretty bad. Can someone double check what I am trying to do? Will they speaker be suitable for a dual 12 that drop down to 80-100?
Excuse my noobness! Trying to learn.
Thanks!
I am looking to build tops to go over some Cubo15/Tham15s and I need them to play pretty low... 80-100hz. I initially thought single 12" were the way to go, but a dual 12" will give me some more height.
I have been looking at Rog's x12 plans , which recommends a P.Audio SN-12MB. Being in Canada that is totally out of the question to get. I do have readily available access to B&C and Eminence though, and I was thinking the B&C 12NDL76 would be a pretty good driver.
So I am assuming after handles, etc the interior volume is going to be around 75l, so I put it into WinISD, but I really don't know what I am doing. I'm not sure what my tuning frequency should be. Assuming it is 50hz which is what the 12NDL76 calls for on specs, the graph seems to fall off pretty bad. Can someone double check what I am trying to do? Will they speaker be suitable for a dual 12 that drop down to 80-100?
Excuse my noobness! Trying to learn.
Thanks!
