do the portsinteract strangleyif not seperated? I dont really see anything in the bandwidth using horn responce?
You might stagger the length of the ports if concerned about port length resonance. You might stagger the location of the ports if concerned about box modes.
Yeah, offsetting the driver @ 60 cm in the 2400 cm2 section followed by the 120cm @ 600cm2 makes an incredibly huge bandwidth(as opposed to placing the driver at the closed end of the 2400cm2 section). Until you delay/tune the other side of the drivers output and all of that gets cancelled out.
so intersting to explore these things in horn response
so intersting to explore these things in horn response
(without the other sides chamberf/vent)
(set ‘path‘ ti near zero to see the full affect )
Attachments
Last edited:
same thing,its just like surfing.
i dunno what’s more intersting? The fact that you don’t excite the ‘3x 1/4 wavelength’ resonance, or you don’t have the big cancellation notch centered on 4x ?
Last edited:
That's exactly what I came up with when using CH1.
You switched on me tho'. You went from a BP6P to a BR.
If
Con = 140.00
Con = 280.00
total = 420.00,
Then how does the
Acoustic Path Length = 471.5?
I'm on my phone.
What does the MEH function do differently from the CH function when modeling a H pattern wave cannon enclosure?
Con = 140.00
Con = 280.00
total = 420.00,
Then how does the
Acoustic Path Length = 471.5?
I'm on my phone.
What does the MEH function do differently from the CH function when modeling a H pattern wave cannon enclosure?
