What would cause this on Q16 ?
Is it from stress or the legs being bent and then bent back ?
Everything appears to be factory ampnhas never been repaired as far as I can tell .
The client bought the amp off someone and wanted it checked over before install .
I cleaned the wire strands from the board that I found so far
Is it from stress or the legs being bent and then bent back ?
Everything appears to be factory ampnhas never been repaired as far as I can tell .
The client bought the amp off someone and wanted it checked over before install .
I cleaned the wire strands from the board that I found so far
Attachments
This amp was dropped off to go through it to make sure everything is fine before installing it
I talked with the guy last night and he wanted all of the caps replaced since they are 20 to 30 years old .
I told him it’s not really necessary to replace them if they still test fine .
Wondering should I replace the caps in this amp or leave them alone and explain to him that they test fine and I would be replacing caps for no reason.
I talked with the guy last night and he wanted all of the caps replaced since they are 20 to 30 years old .
I told him it’s not really necessary to replace them if they still test fine .
Wondering should I replace the caps in this amp or leave them alone and explain to him that they test fine and I would be replacing caps for no reason.
If you've been honest and have confirmed that they're OK and he is willing to pay for the time and cost of parts, replace them. What I don't like is a tech trying to pad the bill by misleading the owner.
