Hello
i was hoping to make some horns for these precision devices
unfortunately there are a few Thiele-Small parameters not available required by hornresp for modeling a horn.
i was just wondering if anyone could help? is there a way of getting around this? has anyone measured this driver?
i was hoping to make some horns for these precision devices
PD.615C002
https://www.precision-devices.com/products/all-products/pd-615c002/. there are a few.unfortunately there are a few Thiele-Small parameters not available required by hornresp for modeling a horn.
i was just wondering if anyone could help? is there a way of getting around this? has anyone measured this driver?
Yeah, they've left out the ones needed to calculate them, though with patience could keep trying different combos till they all lined up close enough or go really simple with a pre-T/S Q0 (attached) using the impedance plot to get a ~Qts to start with, assuming of course that the impedance plot is accurate enough.
