Hey guys got a taramps MD8000 1 ohm model here that has a smoked power supply (output is fine)
I can see it's blown the buffer chips. But I can not read what the part number.
Suspect IC is 'IC3'. The other side of the board seems in better condition but I can not find any other chip with the same numbers as I can make out on the burned IC.
Here are a couple of photos.
One of the burned chip and 1 of the other ICs that are similar.
Cheers guys
I can see it's blown the buffer chips. But I can not read what the part number.
Suspect IC is 'IC3'. The other side of the board seems in better condition but I can not find any other chip with the same numbers as I can make out on the burned IC.
Here are a couple of photos.
One of the burned chip and 1 of the other ICs that are similar.
Cheers guys
Attachments
The IC may be a UCC27324DR. Only use this if no one else can definitively give the part number. It's used in some of the other amps that use the 20 pin MC1.
The two 4.7 ohm resistors appear burned as well.
The two 4.7 ohm resistors appear burned as well.
Thanks Perry yeah did not really go over it with a fine tooth comb just yet 🧐. Just seen I may have trouble finding that IC so stoped there for now
Have you tried contacting Taramps themself. The guys there are very helpful I had a problem with a HD8k and they also went through the fault with me as well as wanting to put me on the data base so I could buy spares direct from them. The only problem was the exchange rate from USD to ZAR.
Last edited: