This is a Raspberry Pi based streamer that I built a while back.
I originally used it with a HifiBerry DAC+ Pro and later with a AMB Gamma2 DAC Module.
There is over $370 in parts here, I am asking $150+shipping.
You can use it as-is, or modify it to your liking.
Parts included here:
1) AMB sigma11 5V regulated PSU (for DAC module) (>$60)
2) Twisted Pear Audio Centaur 5V regulated PSU (for RPi) ($32)
3) Par-Metal 12"x8"x3" Chassis (~$65)
4) Front and rear panels by FPE. Rear panel is partially damaged near the left rear screw (>$120)
5) Schurter filtered IEC socket FN261-4-06 ($12)
6) Kimber FRCA RCA jacks ($30)
7) Raspberry Pi (~$35)
8) Antek 25VA 9V transformer ($18)
AMB gamma2 DAC not included but can be added for an additional $50.
I originally used it with a HifiBerry DAC+ Pro and later with a AMB Gamma2 DAC Module.
There is over $370 in parts here, I am asking $150+shipping.
You can use it as-is, or modify it to your liking.
Parts included here:
1) AMB sigma11 5V regulated PSU (for DAC module) (>$60)
2) Twisted Pear Audio Centaur 5V regulated PSU (for RPi) ($32)
3) Par-Metal 12"x8"x3" Chassis (~$65)
4) Front and rear panels by FPE. Rear panel is partially damaged near the left rear screw (>$120)
5) Schurter filtered IEC socket FN261-4-06 ($12)
6) Kimber FRCA RCA jacks ($30)
7) Raspberry Pi (~$35)
8) Antek 25VA 9V transformer ($18)
AMB gamma2 DAC not included but can be added for an additional $50.
Attachments
Nice setup. Can you tell me more about its capabilities with special regard to the DAC?
How much would be the shipping to Budapest (Hungary)? Thanks!
How much would be the shipping to Budapest (Hungary)? Thanks!
For DAC you can use
- a RaspberryPi HaT module (such as HifiBerry, ALLO, etc) and wire to the RCA jacks,
- the AMB gamma2 module that I have (pictured in last photo). It uses a top of the line WM8741 but its downside is only 1.2V output. You can see it's spec here: The γ2 compact high performance DAC
- Lastly, you can use virtually any USB DAC, in which case one of the PSU's and the RCA jacks are a bit redundant. This unit was built more of an all-in-one.
For shipping, I'll have to check that tomorrow and I'll PM you.
- a RaspberryPi HaT module (such as HifiBerry, ALLO, etc) and wire to the RCA jacks,
- the AMB gamma2 module that I have (pictured in last photo). It uses a top of the line WM8741 but its downside is only 1.2V output. You can see it's spec here: The γ2 compact high performance DAC
- Lastly, you can use virtually any USB DAC, in which case one of the PSU's and the RCA jacks are a bit redundant. This unit was built more of an all-in-one.
For shipping, I'll have to check that tomorrow and I'll PM you.
I have a couple of questions. Which version of the raspberry pi is this and where are you shipping from? Thanks-Roberrt
Inside this unit there is a Raspberry B+, the panel should be fine for a Pi2 or Pi3 as well I believe.
Shipping from Seattle area, although I can take $150 shipping included so that detail is less important.
Shipping from Seattle area, although I can take $150 shipping included so that detail is less important.
