Hi,
Just received and built my nc122mp amplifier, in a ghent audio case.
For now, the amp is always on, but I would like to use a trigger input.
I'm not an electonic guru, so I'd like your approbation before doing anything ^^
I undestand that I have to deal with the ncore module H-bus connector.
Need to cut the J6.3 (PS standby output) to J6.9 (PS Enable) bridge, and add kind of relay that will be open/close according to the mono 3.5mm jack input?
My preamp doesn't have trigger output, so I'll use a wifi/IR outlet with a 5V power supply plugged in on it to trigger the amp.
Any recommandations ?
Thanks
Just received and built my nc122mp amplifier, in a ghent audio case.
For now, the amp is always on, but I would like to use a trigger input.
I'm not an electonic guru, so I'd like your approbation before doing anything ^^
I undestand that I have to deal with the ncore module H-bus connector.
Need to cut the J6.3 (PS standby output) to J6.9 (PS Enable) bridge, and add kind of relay that will be open/close according to the mono 3.5mm jack input?
My preamp doesn't have trigger output, so I'll use a wifi/IR outlet with a 5V power supply plugged in on it to trigger the amp.
Any recommandations ?
Thanks
Last edited:
The simplest solution would be a master-slave power strip, especially if your preamp doesn't have trigger out.
Last edited:
I would prefer a trigger solution, to be able to both use standby mode and delay the amp statup, so that it should avoir "pop" noise in mys speakers on amp statup.